Upper Arms Exercise · Cable
Cable Lying Bicep Curl
- Category
- Upper Arms
- Equipment
- Cable
- Target
- Biceps
Biomechanical cues verified by the PlanWorkouts Science Review Board under CSCS editorial oversight; see our editorial standards.
The Cable Lying Bicep Curl is a targeted isolation upper arms movement designed to train the Biceps.
Single-joint elbow flexion isolated in the sagittal plane. Focuses mechanical load on biceps brachii (long and short heads) and brachialis with minimal torso swinging. Executing this with strict form maximizes muscle fiber recruitment while protecting joint structures.
Quick Exercise Facts
Target Muscle Activation
Curling while lying on a bench or the floor removes the legs and hips from the movement entirely, so the biceps and forearms have to move the cable without any assistance from body lean. It's a stricter angle than a standing cable curl, since there's no room to swing the torso for extra momentum. The constant horizontal cable pull also changes the resistance curve compared to a standing curl against gravity.
How to Do the Cable Lying Bicep Curl
- Clip a straight bar onto a low pulley cable station.
- Lie face-up on a flat bench, planting both feet on the floor.
- Take an underhand grip on the bar with your hands set shoulder-width apart.
- Straighten your arms fully, keeping your elbows tucked close to your sides.
- With your upper arms locked in place, breathe out as you curl the bar up toward your shoulders.
- Hold briefly at the top, contracting your biceps hard.
- Breathe in as you lower the bar back down slowly, straightening your arms completely.
- Perform for your targeted rep count, focusing on a deliberate tempo and maximum tension in the biceps.
Recommended Sets & Reps by Training Goal
65–75% 1RM · 60s rest
50–60% 1RM · 30–45s rest
Controlled 3s eccentric · 60s rest
Biomechanical & Joint Load Cues
Single-joint elbow flexion isolated in the sagittal plane. Focuses mechanical load on biceps brachii (long and short heads) and brachialis with minimal torso swinging.
Common Mechanical Mistakes & Form Errors to Avoid
- Swinging Hips & Lower Back: Using momentum from the hips to swing the weight upward eliminates the initial concentric overload on the biceps.
- Drifting Elbows Forward: Allowing elbows to travel forward past the ribs recruits the anterior deltoids and takes tension off the biceps apex.
- Dropping the Eccentric Phase: Letting the weight fall quickly without resistance wastes 50% of the muscle-building stimulus from eccentric microtrauma.
Proper Breathing Patterns & Core Engagement
Inhale on controlled lowering (2-3s eccentric); exhale on elbow contraction to peak tension.
Add the Cable Lying Bicep Curl to Your Custom Workout Routine
Build a personalized, science-backed workout plan matching your training goals, equipment access, and schedule.
Injury Modification & Joint Safety
Lifters with distal biceps tendinopathy or golfer's elbow (medial epicondylitis) should use neutral-grip hammer curls or EZ-bars to reduce wrist pronation torque. If joint irritation persists, immediately stop and substitute this movement with another exercise from the Upper Arms exercises category.
Muscles Worked
The Cable Lying Bicep Curl primarily targets the Biceps, with Forearms as the primary synergist muscle group.
More Upper Arms Exercises
Assisted Standing Triceps Extension (with Towel)
Assisted Triceps Dip (kneeling)
Band Alternating Biceps Curl
Band Close-Grip Push-Up
Band Concentration Curl
Band One Arm Overhead Biceps Curl
More Biceps Exercises
Barbell Alternate Biceps Curl
Barbell Biceps Curl (with Arm Blaster)
Barbell Curl
Barbell Drag Curl
Barbell Lying Preacher Curl
Barbell Preacher Curl
Equipment Alternatives
Don't have cable? These target the same biceps with different equipment.
Biceps Leg Concentration Curl
Barbell Alternate Biceps Curl
Dumbbell Alternate Biceps Curl
EZ Bar Seated Close Grip Concentration Curl
FAQ
- What muscles does the Cable Lying Bicep Curl work?
- The Cable Lying Bicep Curl primarily targets the biceps as the primary agonist. The forearms acts as the primary supporting muscle group during force transmission. Maintaining strict biomechanical alignment ensures maximal tension remains focused on the intended muscle fibers rather than shifting to surrounding stabilizer joints.
- What equipment do I need for the Cable Lying Bicep Curl?
- The Cable Lying Bicep Curl is performed using a cable. Ensure all equipment is securely positioned with collars or safety pins locked before loading working sets. If you train in a home gym or minimal setup, explore our equipment-free and resistance band alternatives below.
- What is the most common form mistake on the Cable Lying Bicep Curl?
- The most frequent error is swinging hips & lower back: Using momentum from the hips to swing the weight upward eliminates the initial concentric overload on the biceps.. Controlling the 2 to 3-second eccentric lowering phase ensures maximal hypertrophic stimulus while shielding connective tissue.
- How many sets and reps should I perform on the Cable Lying Bicep Curl?
- For muscle growth and density, execute 3 to 4 working sets of 10 to 15 controlled repetitions with 60 seconds rest, emphasizing a deep stretch and deliberate peak contraction on every rep.
- What's a good alternative to the Cable Lying Bicep Curl?
- If you don't have access to a cable, the Biceps Leg Concentration Curl targets the same biceps using body weight instead. This alternative replicates the same joint angle and movement plane while allowing you to train effectively with different available gear. You can also substitute it seamlessly in our free Workout Plan Builder.